If you have the partition set to 1 then there will be only one snap 'step' for each beat.

The first part is correct, the partitions divide the number of steps between each beat (not measures but 'beats'). But if u would like it to snap to each measure then Change the partition setting from 1 to 4? is that correct? lolДЄlso the other thing i was a lil confused about, If you want it to snap to each beat, Then partitions should be set to 1. One of these things should (hopefully) work. If you want to snap to every measure, then change the Numerator to 1 instead of 4. If it still doesn't look like it's snapping, try going into the 'Snap and Grid Setup' option (right-click on the toolbar) and under the Snap/Grid options, make sure the Partition is set to 1. Try zooming in further and see if it looks like it is snapping to the grid. If you have also done that, then you may be zoomed out to far to see that it is snapping to a location. So you can move in both snapped and un-snapped modes depending on which tool bar you click in without having to toggle the snap mode on and off. The top one doesn't follow the snapping movements and the bottom one does. The grid bar is split in to 'two' bars, the top one is blank and the bottom other has timing position numbers. If you have been using the grid bar, also make sure that you are only clicking on the bottom grid bar. To snap the cursor to a new position, you either have to click in the grid/ruler bar or if you are in universal mode, click on the upper half of a waveform to move the cursor. Selecting an object does not move the cursor position, so it will still play from wherever the cursor is currently located. But still when click on a Wavefrom/object/track, it just selects the whole thing, and still plays from the beginning of the file instead of snaping to the start of the nearest measure and playing from there.

Samplitude pro x2 snap to objects